Toshiba MMU-UP0071MH-UL Service Manual page 55

<RBC-AMTU3∗ ∗ ∗ ∗ ∗ >
Procedure
Push [TEST] button for 4 seconds or more.
1
[TEST] is displayed at the display part and
the mode enters in TEST mode.
2
Push [ON/OFF] button.
Change the mode from [COOL] to [HEAT] using [MODE] button.
• Do not use [MODE] button for other mode except
3
[COOL]/[HEAT] modes.
• The temperature cannot be adjusted during test run.
• The trouble detection is performed as usual.
After test run, push [ON/OFF] button to stop the operation.
4
(Display on the display part is same to that in Procedure
Push [TEST] button to clear the TEST mode.
5
([TEST] display in the display part disappears and
status becomes the normal stop status.)
Note) The test run returns to the normal operation after 60 minutes.
TEMP.
TIMER SET
TIME
FILTER
1,
RESET TEST SET CL
5
Operation contents
– 55 –
2,
ON / OFF
4
FAN MODE
3
SAVE VENT
SWING/FIX UNIT LOUVER
1
.)
TEST
TEST