Nortel BCM50 Administration Manual page 85

Msg notify
ADMIN SELECT
Destination:
PHONE EXT PAGER
Pager:
RETRY OK
<x>
ADD OK
Show:<xxxx>
CHNG NEXT
More dest?
YES NO
Msg type: new
CHNG OK
Msg notify
ADMIN SELECT
Chapter 7 Off-premise Message Notification
Press ADMIN or ⁄ to set up Off-premise Message Notification.
3
Press PAGER or ‹ to select a pager number destination.
4
Enter the destination pager number and press OK or £.
5
Press OK or £ to accept the destination pager number represented
6
by <x>
or
press ADD or ¤ to add special characters and use your dialpad or
follow the voice prompts to add characters.
After you add special characters, press OK or £.
Press NEXT or £ to accept the default pager message represented
7
by <xxxx>. The default pager message sent by CallPilot is the
CallPilot extension. This is the sequence of digits that is sent after
the pager service is dialed, to notify you of who is paging you
or
press CHNG or ⁄ to change the pager message.
The combined limit is 30 characters for the pager telephone
number and the pager message.
Press YES or ⁄ if you want to set up another destination number
8
or
press NO or £ if you do not want to set up another destination
number.
Press OK or £ to be notified when the skillset mailbox receives a
9
new message
or
press CHNG or ⁄ to change the message type to be notified only
when the skillset mailbox receives an urgent message.
10 Press ® to end the session.
Call Center Telephone Administration Guide
85