IP Softphone 2050 Settings
Server
Use the Server dialog box to configure the connection between the
IP Softphone 2050 and your communications server. You can either use
the default method (DHCP) or manually specify an IP address.
To open the
Server
of the Settings window.
The following sections describe the Server settings:
•
"Using DHCP" on page 68
•
"Using IP addresses and DNS names" on page 69
•
"Restoring defaults" on page 69
•
"Resetting the connection" on page 69
Using DHCP
With
Automatic (DHCP)
addresses from a Dynamic Host Configuration Protocol (DHCP) server.
Note: To use DHCP, your Local Area Network (LAN) must include a
DCHP server. Contact your System Administrator to set up the server
with the correct IP address values.
To use the Automatic (DHCP) method:
1. Select the
Automatic (DHCP)
2. From the
Server
Primary, Secondary, or Application (XAS) servers.
Note 1: Primary and Secondary servers are assigned by DHCP.
Note 2: XAS support is reserved for future use.
68
dialog box, select
enabled, the IP Softphone 2050 reads server
check box.
list, select your server. You can choose from the
Server
from the list in the left pane