Figure 3-23. Port Configuration Screen (2 Of 2) - Nortel BayStack 450-24T Using Manual

Using the BayStack 450 10/100/1000 Series Switch
Port Trunk
---- ----- ------------
15 [ Enabled
16 [ Enabled
17 1 [ Enabled
18 [ Enabled
19 3 [ Enabled
20 3 [ Enabled
21 [ Enabled
22 4 [ Enabled
23 4 [ Enabled
24 [ Enabled
25 [ Enabled
26 [ Enabled
27 [ Enabled
28 [ Enabled
Switch [ Enable
Stack [ Enable
Press Ctrl-P to display choices for ports 1-14.
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu.
Figure 3-23. Port Configuration Screen (2 of 2)
Note: When a gigabit MDA is installed, only the Status field for that MDA
port is configurable. See "High Speed Flow Control Configuration" on
page 3-62 to set the Autonegotiation field for the gigabit MDA port. Gigabit
MDAs only support 1000 Mb/s in full-duplex mode.
Table 3-20 describes the Port Configuration screen fields.
3-60
Port Configuration
Unit:
Status Link
-----
] Down
] Down
] Up
] Down
] Up
] Up
] Down
] Up
] Up
] Down
] Down
] Down
] Down
] Down
]
]
[ 1 ]
LnkTrap Autonegotiation
------- ---------------
[ Off ] [ Disabled ]
[ Off ] [ Disabled ]
[ On ] [ Enabled
[ On ] [ Disabled ]
[ On ] [ Enabled
[ On ] [ Enabled
[ On ] [ Enabled
[ On ] [ Enabled
[ On ] [ Enabled
[ On ] [ Disabled ]
[ Off ] [ Disabled ]
[ Off ] [ Disabled ]
[ Off ] [ Disabled ]
[ Off ] [ Disabled ]
[ On ] [ Enable
[ On ] [ Enable
Press Ctrl-C to return to Main Menu.
Speed Duplex
-----------------
[ 10Mbs / Full ]
[ 100Mbs / Full ]
] [ 100Mbs / Full ]
[ 100Mbs / Half ]
] [ 100Mbs / Full ]
] [ 100Mbs / Full ]
] [ 100Mbs / Full ]
] [ 100Mbs / Full ]
] [ 100Mbs / Full ]
[ 100Mbs / Full ]
[ 100Mbs / Full ]
[ 100Mbs / Full ]
[ 100Mbs / Full ]
[ 100Mbs / Full ]
] [ 100Mbs / Full ]
] [ 100Mbs / Full ]
309978-D Rev 01