Installation
Hazard Alert Messages
Read and observe all hazard alert messages in this publication. They
provide information that can help prevent serious personal injury,
damage to components, or both.
WARNING
To prevent eye injury, always wear eye protection when perform-
ing vehicle maintenance or service.
Printed in USA
Installing the Transfer Case Assembly
1.
Place the transfer case onto a transmission jack.
2.
Position the transmission jack underneath the vehicle. Some
vehicles may require that one side be jacked up in order to
achieve suffi cient clearance to place the transfer case between
the frame rails.
3.
Raise the transmission jack to correctly position the transfer case.
4.
Install the transfer case at the mounting points. Since mounting
designs vary, consult the vehicle service manual.
5.
Connect the drivelines.
6.
Connect the speedometer cable.
7.
Connect the shift cylinder air lines.
8.
Connect the indicator light and temperature sensor wires.
9.
Fill the housing to the correct level using the appropriate lubricant
and install the level plug.
10. Check the transfer case for leaks around the gaskets and seals.
Copyright Meritor, Inc., 2021
8
Installation
MM-2034 / Issued 02-21
Page 46