Table of Contents
Advertisement
5
Disassembly
26. Remove the yoke nut and yoke from the front input seal carrier.
Figure 5.26.
Figure 5.26
27. Remove the input seal carrier assembly from the housing. Discard
the gasket and clean both surfaces. Figure 5.27.
Input Seal
Carrier
Figure 5.27
MM-2034 / Issued 02-21
Page 15
28. Remove and discard the input seal. Inspect the o-ring and replace
if necessary. Figure 5.28.
Figure 5.28
29. Using a piece of brass or other soft material, lightly tap the input
shaft toward the front of the case to drive out the front bearing
4018218a
cup. Figure 5.29.
Figure 5.29
4018219a
Copyright Meritor, Inc., 2021
O-ring
Drive Out
Front Bearing
Cup on the Other
Side of the Case
4018220a
4018221a
Printed in USA
Advertisement
Table of Contents
