Meritor MTC Series Maintenance Manual page 38

7 Assembly
9. Install a new seal into the input shaft seal carrier using an arbor
press or similar. Ensure the o-ring is seated properly in the seal
carrier groove. Figure 7.33.
O-ring
Figure 7.33
10. Install the input shaft seal carrier with bracket into the case using
a new gasket. Use Loctite 272 threadlocker on the bolt threads
and torque to specifi cation in a crisscross pattern. Figure 7.34.
Figure 7.34
MM-2034 / Issued 02-21
Page 35
4018220a
4018266a
Copyright Meritor, Inc., 2021
11. Install the rear-most input shaft support bearing (heated) and
bearing lock nut, using Loctite 290 threadlocker on the threads.
Torque to specifi cation. Figure 7.35.
Figure 7.35
12. Install the rear outer bearing cup into housing followed by the
bearing cup spacer. Figure 7.36.
Figure 7.36
4018267a
4018268a
Printed in USA