Handling Removed Components - Meritor MTC Series Maintenance Manual

Front Output Shaft
1. Then remove the front output carrier, both bearings, spacer, and
front output shaft gear. Figure 5.45.
PRESS
Figure 5.45

Handling Removed Components

Remove additional components as required.
• Clean and dry all parts using the guidelines indicated in the
foreword to this manual.
• Examine all parts for wear or damage from misuse or poor
handling.
• Discard and replace any damaged parts.
• All bearings with disassembly loads through the rollers and races
must be discarded and replaced.
Printed in USA
4018234a
Copyright Meritor, Inc., 2021
5 Disassembly
MM-2034 / Issued 02-21
Page 20