Table of Contents
Advertisement
5.
Install the new seal onto the spline shaft neck. Ensure that the
small diameter side fi ts onto the splines fi rst. Figure 5.13.
SMALL
DIAMETER
Fig. 5.13
6.
Align the slip yoke and spline shaft sections with the phasing
marks you made on these sections during disassembly.
Figure 5.14.
PHASING MARKS
Fig. 5.14
7.
Install the spline shaft into the slip yoke until the splines fully
engage. Figure 5.14.
8.
Snap the seal into the groove. Figure 5.15.
SEAL
Fig. 5.15
9.
Snap the shroud over the seal. Figure 5.16.
(16579)
Printed in USA
LARGE
DIAMETER
4001829d
4001831b
Copyright Meritor, Inc., 2021
5
SHROUD
Fig. 5.16
10. Push together the driveline sections. Figure 5.17.
Fig. 5.17
11. Reinstall the grease fi ttings.
Installation
Universal Joint
CAUTION
Do not use grease or anti-seize compound in the yoke ear bores.
Damage to components can result.
1.
Clean dirt and contamination from the slip yoke and weld yoke
ear bores.
NOTE: The defl ector is preassembled onto the bushing.
2.
Position the fi rst bushing onto the trunnion by threading the
cross trunnion through the yoke bore. Figure 5.18.
RPL Series Permalube
4018246a
MM-96147 / Revised 03-21
Page 21
Advertisement
Table of Contents
