5.
Rotate the housing and place into a suitable assembly stand or on
a sturdy workbench. Figure 7.29.
Figure 7.29
6.
Place the direct drive gear into the housing. Install the input shaft
into the housing while passing it through the direct drive gear.
Figure 7.30.
Figure 7.30
Printed in USA
7.
Figure 7.31
4018195a
8.
Figure 7.32
4018263a
Copyright Meritor, Inc., 2021
Reinstall the rear bearing onto the input shaft. Figure 7.31.
Install the front bearing cup into the housing, leaving it protruding
slightly. Figure 7.32.
7
Assembly
4018264a
4018265a
MM-2034 / Issued 02-21
Page 34