21. Install the direct drive gears onto the intermediate and rear output
shafts until the retaining rings are fully seated into the grooves on
both of the direct drive gears. Figure 7.45.
Figure 7.45
22. Install the heated bearings onto the intermediate and rear output
shafts. Figure 7.46.
Bearings
Figure 7.46
Printed in USA
23. Install a washer and lock nut onto the intermediate shaft using
Loctite 290 threadlocker on the threads. Torque to specifi cation.
Figure 7.47.
4018277a
Figure 7.47
24. Slide the spacer onto rear output shaft. Figure 7.48.
Figure 7.48
4018278a
Copyright Meritor, Inc., 2021
7
Assembly
4018279a
4018280a
MM-2034 / Issued 02-21
Page 38