Table of Contents
Advertisement
MX5, MX10, MX40, and MX80 Universal Routing Platforms Hardware Guide
Troubleshooting the MX5, MX10, MX40, and MX80 MICs
Problem
Solution
See Also
Troubleshooting the MX5, MX10, MX40, and MX80 Power Supplies
Problem
Solution
130
show chassis alarms
show chassis temperature-thresholds
Description: The MICs are not functioning normally.
Check the status of each port on a MIC by looking at the LED located on the MIC
faceplate. For information about the meaning of LED states on different MICs, see the
MX Series Interface Module Reference
Check the status of a MIC by issuing the
MIC slots in the MX5, MX10, MX40, and modular MX80 router are labeled
. The fixed MIC is labeled
1/MIC 1
user@host> show chassis fpc pic-status
Slot 0
Online
PIC 0
Online
PIC 2
Online
PIC 3
Online
Slot 1
Online
PIC 0
Online
PIC 1
Online
PIC 2
Online
PIC 3
Online
For further description of the output from the command, see the
MX5, MX10, MX40, and MX80 Modular Interface Card Description on page 43
show chassis fpc
Description: The power supply is not functioning normally.
Check the LEDs on each power supply faceplate. If a power supply is correctly installed
and functioning normally, the status LED on the power supply lights green steadily.
Issue the CLI
show chassis environment pem
power supplies. As shown in the sample output, the value
State
indicates that each of the power supplies is functioning normally:
user@host> show chassis environment pem
PEM 0 status:
State
Temperature
.
show chassis fpc pic-status
.
0/MIC 0
4x 10GE XFP
1x 10GE XFP
1x 10GE XFP
1x 10GE XFP
1x 10GE XFP
1x 10GE XFP
1x 10GE XFP
command to check the status of installed
Online
OK
CLI command. The
1/MIC 0
.
CLI Explorer
in the rows labeled
Online
Copyright © 2019, Juniper Networks, Inc.
and
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
