Replacing An Mx5, Mx10, Mx40, And Mx80 Mic; Removing An Mx5, Mx10, Mx40, And Mx80 Mic - Juniper MX5 Hardware Manual

MX5, MX10, MX40, and MX80 Universal Routing Platforms Hardware Guide
Action
See Also

Replacing an MX5, MX10, MX40, and MX80 MIC

104
On a regular basis:
Check the LEDs on MIC faceplates. The meaning of the LED states differs for various
MICs. For more information, see the
detects a MIC failure, the router generates an alarm message to be sent to the Routing
Engine.
Issue the CLI
show chassis fpc pic-status
MX40, and modular MX80 router are numbered
numbered 0/MIC 0 .
user@host> show chassis fpc pic-status
Slot 0 Online
PIC 0 Online
PIC 2 Online
PIC 3 Online
Slot 1 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
show chassis fpc
Removing an MX5, MX10, MX40, and MX80 MIC on page 104
Installing an MX5, MX10, MX40, and MX80 MIC on page 106
Installing an MX10, MX40, MX80, and MX104 Dual-Wide MIC on page 109

Removing an MX5, MX10, MX40, and MX80 MIC

MICs are hot-insertable and hot-removable. When you remove a MIC, the router continues
to function, although the MIC interfaces being removed no longer function.
In the MX5, MX10, MX40, and modular configuration of the MX80 router, the MICs can
be installed in two slots in the front of the router. A MIC weighs less than 2 lb (0.9 kg).
To remove a MIC (see Figure 43 on page 106
Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the
1.
MIC. If the MIC connects to fiber-optic cable, have ready a rubber safety cap for each
transceiver and cable.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Use one of the following methods to take the MIC offline:
3.
MX Series Interface Module Reference
command. The MIC slots in the MX5, MX10,
1/MIC 0
4x 10GE XFP
1x 10GE XFP
1x 10GE XFP
1x 10GE XFP
1x 10GE XFP
1x 10GE XFP
1x 10GE XFP
and Figure 44 on page
. If the router
and . The fixed MIC is
1/MIC 1
106):
Copyright © 2019, Juniper Networks, Inc.