Field Setting from Remote Controller
2.4.4 Setting of Operation Control Mode from Remote Controller
(Field Setting)
The operation control mode is compatible with a variety of controls and operations by limiting the functions of the operation
remote controller. Furthermore, operations such as remote controller ON/OFF can be limited in accordance with the
combination conditions. (Refer to information in the table on the next page.)
Centralized controller is normally available for operations. (Except when centralized monitor is connected)
2.4.5 Contents of Control Modes
20 modes consisting of combinations of the following 5 operation modes with temperature and operation mode setting by
remote controller can be set and displayed by operation modes 0 through 19.
ON/OFF control impossible by remote controller
Used when you want to turn ON/OFF by central remote controller only.
(Cannot be turned ON/OFF by remote controller.)
OFF control only possible by remote controller
Used when you want to turn ON by central remote controller only, and OFF by remote controller only.
Centralized
Used when you want to turn ON by central remote controller only, and turn ON/OFF freely by remote controller during
set time.
Individual
Used when you want to turn ON/OFF by both central remote controller and remote controller.
Timer operation possible by remote controller
Used when you want to turn ON/OFF by remote controller during set time and you do not want to start operation by
central remote controller when time of system start is programmed.
102
SiUS30-1301
Field Setting