Steer Bellcrank - Terex Genie GS-1532 Service And Repair Manual

Service and Repair Manual
Steer Axle Components
6-3

Steer Bellcrank

How to Remove the Steer
Bellcrank
1 Remove the steer cylinder. Refer to Repair
Procedure, How to Remove the Steer
Cylinder.
2 Remove the retaining fasteners from the steer
links at each end of the bellcrank.
Note: While removing the retaining fasteners, take
note of the quantity and location of the spacers
between the bellcrank and the steer links.
3 Center a lifting jack under the drive chassis at
the steer end of the machine.
4 Raise the machine approximately 14 inches /
36 cm. Place blocks under the chassis for
support.
Crushing hazard. The chassis
will fall if not properly supported.
5 Turn the yokes to the side so the bellcrank
can be removed.
74
6 Remove the bellcrank from the machine.
Note: While removing the bellcrank from the
machine, take note of the quantity and location of
the spacers between the bellcrank and the steer
links.
Note: Before re-installing the steer bellcrank onto
the machine, apply a small amount of removable
thread lock onto the threads of the fasteners.
Torque the fasteners to 31 ft-lbs / 42 Nm.
GS ™ -30 • 32 • 46 • 47
1 apply removable thread lock to fastener
threads
Part No. 1272217GT
March 2021