Setting Items Requiring Control By The Printer For Each Printing Or Status Change (Aculaser C100) - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000
Duplex Printing
Selects simplex printing or duplex printing.
NOTE: AcuLaser C1000 permits duplex printing only when the paper
size is A4 or LT. With any other paper size, selection of duplex
printing is invalid, displaying the error message "Can't print
duplex".
RITech
The RITech function is enabled or disabled by RITech setting.
Toner Save
Selects whether the Toner Save function is enabled or disabled.
Top Offset
Sets the print starting vertical position on a sheet.
The printer permits setting in the range of about -30.0 ~ 30.0 mm in 1-dot
increments, while setting by the driver is limited to -9 ~ 9 mm in 1-millimeter
increments.
Binding margins for duplex printing with the Top Offset setting value are
limited to 0 ~ 30 mm in 1-millimeter increments.
Left Offset
Sets the print starting horizontal position on a sheet.
The printer permits setting in the range of about -30.0 ~ 30.0 mm in 1-dot
increments, while setting by the driver is limited to -9 ~ 9 mm in 1-millimeter
increments.
Binding margins for duplex printing with the Top Offset setting value are
limited to 0 ~ 30 mm in 1-millimeter increments.
Paper Type
Printing speed, fuser temperature and other necessary settings are
determined for the paper type for use.
Size Ignore
Selects whether or not to ignore the errors "Paper Set" and "Check Paper
Size".
Product Descriptions
Avoid Error
Selects whether or not to avoid occurrence of any of the followings:
"Paper Set", "Invalid Size", "Mem Overflow", "Duplex Mem Overflow"
ON:
OFF:
NOTE: "Avoid Error" is intended not to suspend the printer for an
1.5.3.3 Setting Items Requiring Control by the Printer for
Each Printing or Status Change (AcuLaser C100)
Table 1-37. Setting Items Requiring Control by the Printer
Total Pages
Color Pages
MP Tray Feed Counter
LC 1 Feed Counter
LC 2 Feed Counter
Jam Counts
C Toner Change
M Toner Change
Y Toner Change
K Toner Change
Photoconductor Change
Oil Toll Change
Control Panel (AcuLaser C1000)
The printer continues printing without displaying any of the above
errors.
"Paper Set" does not occur, but "Check Paper Size" appears if the
paper size of the fed sheet is not as designated.
None of "Invalid Size", "Mem Overflow", and "Duplex Mem
Overflow" occurs, but "Print Failure" appears.
Once any of the aforementioned errors occur, the printer will not
recover until receiving a release command through the
ESCPAGES-02 protocol.
extended period of time under conditions where sufficient
monitoring of the printer is not available, for example, in the
case of printing with the printer used as a shared printer.
for Each Printing or Status Change
Control Item
0 ~ 99999999 pages
0 ~ 99999999 pages
0 ~ 150 pages
0 ~ 500 pages
0 ~ 500 pages
0 ~ 65535 times
0 ~ 255
0 ~ 255
0 ~ 255
0 ~ 255
0 ~ 255
0 ~ 255
Revision E
Range of Values
56