Printer Setting Items (Aculaser C100); Setting Items For Which Printer Stores Settings - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000

1.5.3 Printer Setting Items (AcuLaser C100)

This section describes setting items for AcuLaser C1000.
NOTE: Since there are no character strings administrated by the printer,
the names of setting items and setting values referred to below are
only for explanation. Therefore, these names may not match
character strings displayed in driver's user interfaces or the Status
Sheet.

1.5.3.1 Setting Items for which Printer Stores Settings

Values shown in bold and underlined characters are the factory default setting
values.
Table 1-34. Setting Items for which Printer Stores Settings
Setting Item
Standby 30, 60, 120, 180, OFF
Paper Source Priority MP Tray * 1 , LC *
A4 * 1 , A5, B5, LT *
MP Tray Size
C6, IB5, Yokei#0 *
Toner Out Error Stop, Continue
*1: The default setting is determined depending on the intended market.
*2: JIS envelope.
Standby
Sets the power saving function to reduce power consumption when the
printer is in the standby mode.
The printer can use five setting values, while the driver is limited to:
ON (30 minutes), OFF
Paper Source Priority
Sets a priority order when Auto Selection is selected by Paper Source
setting and paper sources match the designated paper size.
This is the same function as the "MP Mode" function of ESC/Page models.
MP Tray: MP tray > cassette 1 > cassette 2
LC: Cassette 1 > cassette 2 > MP tray
LC only: Cassette 1 > cassette 2
However, when printing is to be continued without any paper source which
Product Descriptions
Setting Values
1 , LC ONLY
1 , HLT, GLT, EXE, F4, MON, C10, DL, C5,
2 , Yokei#4 * 2 , Yokei#6 * 2
Control Panel (AcuLaser C1000)
has any paper of the designated paper size, paper will be fed from paper
sources that have paper in the order of MP tray > cassette 1 > cassette 2 if
Paper Source Priority is set to MP Tray or LC. Or paper will be fed from
paper sources that have paper in the order of cassette 1 > cassette 2 if
Paper Source Priority is set to LC ONLY.
The default setting of Paper Source Priority for AcuLaser C1000 is "MP
Tray".
"LC ONLY" is a method which replaces ESC/Page models' function
realized by recognition of paper types.
MP Tray Size
Assigns a paper size for the MP tray.
If when printing continues after the "Paper Set" error occurrence, the paper
size designated by the printing data matches the paper size that is actually
fed, the paper size will be stored in memory.
The default value is either "A4" or "LT" depending on the jumper setting
(JP101/INPT1) on the controller board.
The paper sizes which can be handled by the MP Tray Size function of
AcuLaser C1000 driver is limited to:
A4, A5, B5, LT, HLT, GLT, EXE, MON, C10, DL, C5, C6, IB5
Toner Out Error
Selects whether "uuuu Toner Out" is to be indicated and printing is to be
stopped or "uuuu Toner Low" is to be kept indicated when the amount of
remaining toner indicated by the toner counter reaches 0%.
This function is the same as the "Toner Out" function of ESC/Page models.
Revision E
54