EPSON AcuLaser C2000 / AcuLaser C1000
4.2.4 C314MAIN Board
4.2.4.1 C314MAIN Board Removal
1. Remove the Rear Controller Cover (See "Rear Controller Cover Removal"
on page 145.)
2. Remove 7 screws securing the C314MAIN Board to the Controller Box.
Interface Cover
Figure 4-14. C314MAIN Board Removal
Disassembly and Assembly
3. Remove a screw (A) securing the C314MAIN Board and an earth wire of
the Control Panel harness.
Remove the harness from the connector of the MAIN Board.
(B)
(B)
(B)
(B)
(
Figure 4-15. Screws of the C314MAIN Board (1)
4. Remove 6 screws (B) securing the Controller Box to the C314MAIN Board.
5. Pull out the C314MAIN Board with the Interface Cover.
Disassembling Procedure
Revision E
Control Panel Harness
(B)
(A)
Guide Rail
(B)
(B)
148