Epson ACULASER COLOR 2000 Service Manual page 118

EPSON AcuLaser C2000 / AcuLaser C1000
Remedy: When the cover is closed, the error will disappear, thus the
pop-up display of the EPSON Status Monitor will
disappear.
Paper Out
Description: Since the selected paper source is not loaded with paper,
operation stops before printing.
When paper is detected in the selected paper source, the
printer will recover from the error and start printing.
Even if all the paper sources have no paper, the error
does not appear unless printing is activated.
Remedy: When paper is inserted in the selected paper source, the
error will disappear, thus the pop-up display of the EPSON
Status Monitor will disappear.
Paper Set
Description: Since the paper size specified by printing data differs from
the paper size recognized by the size detecting means of
the Paper Source, operation stops before printing.
The Continue command of the ESCPAGES-02 protocol
releases the printer engine from the error, thus the printer
recovers from the error and starts printing. The
ResetPrinter command releases the printer engine from
the error in the printer engine, resetting the printer to the
initial status.
This error does not occur when the specified paper size is
an undefined paper size, or when "Size Ignore = ON" or
"Avoid Error = ON" is selected.
Remedy: Insert appropriate paper and select [Continue] in the
EPSON Status Monitor.
When driver settings are to be changed for reprinting,
select [Cancel Printing] in the EPSON Status Monitor.
Invalid Size
Description: Since a larger paper size than A4/LT such as A3 is
specified, or a different feeding direction is selected such
as A4 Long Edge Feed, operation stops before printing.
The Continue command of the ESCPAGES-02 protocol
releases the printer from the error, and printing resumes
Troubleshooting
from the next page. When "Avoid Error = ON" is set, the
printer displays the "Print Failure" error status instead of
this error, and resumes printing the next page.
Remedy: To print pages subsequent to the occurrence of "Invalid
Size", select [Continue] in the EPSON Status Monitor.
When driver settings are to be changed for reprinting,
select [Cancel Printing] in the EPSON Status Monitor.
Actually, the printer driver will clip image to A4 or Letter
size, so this error will not occur.
Print Underrun
Description: Printing was not successful since the data constituting the
band for printing was not completely received at printing
by flying start, or the memory was insufficient after a flying
start due to "Near Buffer Full".
Resetting the printer to the initial status by the
ResetPrinter command of the ESCPAGES-02 protocol
releases the printer from the error.
Remedy: If data receiving is not completed, select [Reprint] in the
EPSON Status Monitor, and the driver will resend data
without a flying start, so that printing can be performed
successfully in some cases.
When driver settings are to be changed for reprinting,
select [Cancel Printing] in the EPSON Status Monitor.
Mem Overflow
Description: Data for one page was not saved due to an insufficient
memory.
The Continue command of the ESCPAGES-02 protocol
releases the printer from the error, and printing resumes
from the next page. When "Avoid Error = ON" is set, the
printer displays the "Print Failure" error status instead of
this error, and resumes printing the next page.
Remedy: To print pages subsequent to the occurrence of "Mem
Overflow", select [Continue] in the EPSON Status Monitor.
When driver settings are to be changed for reprinting,
select [Cancel Printing] in the EPSON Status Monitor.
Printer Message
Revision E
118