Config Menu (Aculaser C2000) - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000
<If Page Size=A4, LT>
When Paper Type = Normal
If Paper Source = Auto,
From the paper feeders where the paper type specified by a language
and available tray in the table above matches, the paper feeder which
also matches the specified paper size is selected.
If Paper Source = MP, LC1 or LC2, specified paper feeder is selected
When Paper Type = Thick, Transprnc
The paper feeder used is always the MP tray
Engine control
Paper Type setting always takes priority.
When Paper Type=Normal, engine control is performed based on the
specified value for the selected tray.
NOTE: The type of paper specified when selecting a paper feeder is
specified only by a command in ESC/Page or ESC/Page-Color or
LJ4.
NOTE: "Bond" is not used to avoid the confusion with "Thick".

1.4.5.3 Config Menu (AcuLaser C2000)

RITech
See the description in the RITech item in the 97SIS-565 Basic Page-Printer
Operating Specifications. This is an outline correction function which is
equivalent to that in a single color page printer in B/W printing. In color printing,
When in the AcuLaser Color Halftoning mode, outline correction is
accomplished by the CRIT function.
Toner Save
See the description in the Toner Save item in the 97SIS-565 Basic Page-
Printer Operating Specifications. During color printing, by controlling the half-
tone growth and by printing with a low density, toner consumption is reduced.
Product Descriptions
Paper Type
This sets the printing speed and CM to match the type of paper used.
Normal (Copy paper, recycled paper, J paper, etc.)
Cases where Paper Source = MP, LC1, LC2 or Paper Source = Auto,
and the type of paper used is not specified.
Printing Speed: Standard Mode
CM: As shown below in accordance with the CM Media Type value in
the ESC/Page Menu.CM Media Type: CM Off: Plain Paper
Opt1:Option1 Opt2: Option2
Cases where Paper Source = Auto and the type of paper used is
specified.
Printing Speed :As shown below in accordance with the type of paper
set in the paper feeder that actually feeds the paper (set according to
the MP, LC1/2 Type in the Tray Menu).
CM :
Control Panel (AcuLaser C2000)
Paper Type Printing Speed
Plain Standard Mode
Letterhead Standard Mode
Recycled Standard Mode
Color Standard Mode
Trnsprncy Half-speed Mode
Labels Half-speed Mode
As shown below in accordance with the CM Media
Type value in the ESC/Page Menu
CM Media Type CM
Off *1 See Note 1 below.
Opt1 Option1
Opt2 Option2
*1: When the CM Media Type is Off, the setting is as fol-
lows in accordance with the type of paper selected.
Revision E
49