Epson ACULASER COLOR 2000 Service Manual page 120

EPSON AcuLaser C2000 / AcuLaser C1000
Worn Photoconductor
Explanation
This is a warning message that informs the user that the
Photoconductor Unit has almost reached the end of its service life.
Photoconductor in the Setup Menu becomes less than 20%.
Treatment Method
Use of the photoconductor unit is possible until the "Replace
Photocondctr" error is displayed, but basically, it is better to replace it
right away. Display of this message is canceled by any one of the
following.
1) Press the Continue switch.
2) Reset the printer.
3) Replace the Photoconductor Unit with a new one. At the same
time, Fuser Oil Roll, Waste Toner Collector and Print Head Filter
should be replaced.
Waste T Box Nearfull
Explanation
This warning message notifies the user that the Waste Toner Collector
is nearly full. The Waste Toner When Collector full state is detected,
this warning is produced.
Treatment Method
Basically, it is better to replace it right away. Or exchanging
Photoconductor Kit will also do. Display of this message is canceled by
any one of the following.
1) Press the Continue switch.
2) Reset the printer.
3) Replace the Waste Toner Collector with a new one.
Troubleshooting
Worn Fuser
Explanation
This is a warning message that informs the user that the Fuser Unit
has almost reached the end of its service life.
Treatment Method
Use of the Fuser unit is possible until the "Replace Fuser" error is
displayed, but basically, it is better to replace it right away. Display of
this message is canceled by any one of the following.
1. Press the Continue switch.
2. Reset the printer.
3. Replace the Fuser Unit with a new one. At the same time, 2nd
Transfer Roll should be replaced.
Oil Roll Near Empty
Warning is issued when Fuser Oil Roll remaining becomes 20%. The
engine counts Fuser Oil Roll remaining.
Remedy:
Use of the Oil Roll is possible until the "Replace Oil Roll" error is
displayed, but basically, it is better to replace it right away. Display of
this message is canceled by any one of the following.
1. Press the Continue switch.
2. Reset the printer.
3. Replace the Fuser Oil Roll with a new one.
Printer Message
Revision E
120