One Touch Setting Modes (Aculaser C2000); Panel Setting Item List (Aculaser C2000) - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000
Value button (N)
Pressing this button enables the item that was last selected.
In OneTouch mode 1, used to select the value for "Manual Feed".
In OneTouch mode 2, used to select the value for "MP Tray Size".
In SelecType mode, used to select the value for the currently selected
setting item. The next available value for the item is indicated.
NOTE: If this button is pressed with the Shift button held down, setting
values and items scroll backward.
Enter button (O)
Pressing this button generates "Status Sheet" in "Test Menu".
In OneTouch mode 1, used to select the value for "Orientation".
In OneTouch mode 2, used to select the value for "Toner Save Mode".
In SelecType mode, the setting value is confirmed and printing or other
functions are activated.
NOTE: If this button is pressed with the Shift button held down, setting
values and items scroll backward.
Reset button (Continue button + Alt button) (K + J)
Pressing this button with the Alt button held down causes the printer to stop
printing and reset. After the message "Reset" is indicated on the LCD, if the
both buttons are kept pressed for more 5 seconds, "Reset All" is indicated and
warm boot is performed.
1.4.3 One Touch Setting Modes
In the AcuLaser Color 2000, One Touch Setting Modes are as follows.
Product Descriptions
(AcuLaser C2000)
Control Panel (AcuLaser C2000)
One Touch Setting Mode 1 (from left)
Paper Source
Page Size
Manual Feed
Orientation
One Touch Setting Mode 2 (from left)
RITech
Copies
MP Tray Size
Toner Save Mode
1.4.4 Panel Setting Item List
Test Menu
Item
Status Sheet
*1
Network Status Sheet
AUX Status Sheet *2
PS3 Status Sheet *3
PS3 Font Sample *3
ESC/Page Font Sample *4
LJ4 Font Sample
ESCP2 Font Sample
FX Font Sample
I239X Font Sample
*1: Displayed and can be executed only when the Network I/F=On.
*2: Displayed and can be executed only when the printer is equipped with Level 3
compatible Type B host interface and AUX I/F=On at start-up.
*3: Displayed and can be executed only when the Optional PostScript 3 module is
installed.
*4: Not displayed in the panel. It can be set in EJL. It is not open to users.
Revision E
(AcuLaser C2000)
Value
40