Printer Mechanism Disassembly; Cr Motor Removal - Epson STYLUS COLOR 3000 Service Manual

Disassembly and Assembly

Printer Mechanism Disassembly

Pages 3-16 through 3-37 describe procedures for printer mechanism disassembly.

CR Motor Removal

1. Remove the upper housing (See page 3-4).
2. Remove the printer mechanism. (See page 3-10).
3. Disconnect the belt tension spring to loosen the timing belt.
4. Remove the timing belt from the pulley on the CR motor.
5. Release the joint for the CR motor and base frame by turning the motor counterclockwise in the order
shown by steps 1 to 3 in Figure 3-13. Then remove the CR motor by pulling it toward the bottom edge of
the base frame.
CR Motor
Base Frame Assembly
Figure 3-13. CR Motor Removal
The CR motor fan and CR motor are 2 separate parts. Therefore, mount the CR motor fan with
the specified adhesive when replacing the CR motor. Leave between 0-2 mm at the end of the
CR motor shaft, as shown in Figure 3-14.
3-16
CR Motor Pulley
Belt Tension Spring
Timing Belt
CR Motor Assembly
CAUTION
Shaft End: 0~2 mm
Figure 3-14. Adhering the CR Motor and Fan
EPSON Stylus Color 3000 Service Manual
Adhesive
Indent side facing outward
CR Motor Fan