D-Link DIR-882 User Manual page 285

DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Additional settings are also available on the page:
Parameter
Get NTP server
addresses using DHCP
Run as a server for the
local network
Time interval between
NTP requests after
synchronization with
NTP server
Time interval between
NTP requests for
unsynchronized NTP
client
Interval value
After specifying the needed parameters, click the APPLY button.
When the router is powered off or rebooted, the system time is reset to the default value.
!
If you have set automatic synchronization for the system time, the internal clock of the
device will be configured after connecting to the Inter net. If you have set the system time
manually, you need to set the time and date again (see above).
Move the switch to the right if NTP servers addresses are provided
by your ISP. Contact your ISP to clarify if this setting needs to be
enabled.
If the switch is moved to the right, the NTP Servers section is not
displayed.
Move the switch to the right to allow connected devices to use the IP
address of the router in the local subnet as a time server.
From the drop-down list, select a time period (in seconds) after
which a request to update the system time will be sent to the NTP
server or leave the Auto value.
A time period (in seconds) after which a request to synchronize the
system time will be sent to the NTP server.
Select the needed value from the drop-down list.
•
Auto: The time period is defined automatically.
• Manual: The time period is defined in accordance with the
value specified in the Interval value field.
Specify the time period (in seconds). The minimum acceptable value
is 3.
Page 285 of 303
Configuring via Web-based Interface
Description