D-Link DIR-882 User Manual page 114

DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Figure 95. The page for creating a new IPIP6 connection. The IP section.
Parameter
Obtain remote host
address automatically
Remote host
Mode
Set MTU automatically
MTU
When all needed settings are configured, click the APPLY button.
After clicking the button, the window for additional configuration of the connection opens.
If you want to use this WAN connection to access the Internet, select the to the Internet choice of
the radio button. Then select an existing connection which will be used to access the VPN server or
select the create a new connection choice of the radio button and click the CONTINUE button.
If you have already configured the connection to the Internet and you want to use this WAN
connection only to connect to the virtual private network, select the to the virtual private
network choice of the radio button. Then select an existing connection which will be used to
access the VPN server or select the create a new connection choice of the radio button and
click the CONTINUE button.
IP
Move the switch to the right to configure automatic assignment of a
remote host IPv6 address.
Enter the remote host IPv6 address.
The field is available for editing, if the Obtain remote host
address automatically switch is moved to the left.
An operation mode of the connection.
From the drop-down list, select the DSLite value.
Move the switch to the right to set the maximum size of units
transmitted by the interface automatically.
Move the switch to the left to specify this parameter manually.
Upon that the MTU field is displayed.
The maximum size of units transmitted by the interface.
Page 114 of 303
Configuring via Web-based Interface
Description