D-Link DIR-882 User Manual page 134

DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Parameter
Dynamic IPsec
Type
Remote host
Identifier value
Pre-shared key
Local WAN
NAT Traversal
Move the switch to the right to allow a remote host with any public IP
address to connect to the router via IPsec protocol. Such a setting can
be specified for one IPsec tunnel only. Connection requests via this
tunnel can be sent by a remote host only.
Select an identification method for the remote host (router) from the
drop-down list:
•
Address: The remote host is identified by its IP address.
• FQDN: The remote host is identified by its domain name.
The drop-down list is displayed if the Dynamic IPsec switch is
moved to the left.
Enter the remote subnet VPN gateway IP address if the Address
value is selected from the Type drop-down list.
Enter the remote subnet VPN gateway domain name if the FQDN
value is selected from the Type drop-down list.
The field is available for editing if the Dynamic IPsec switch is
moved to the left.
Specify a unique name of the tunnel.
A PSK key for mutual authentication of the parties.
icon ( ) to display the entered key.
A WAN connection through which the tunnel will pass. Select a value
from the drop-down list.
• Interface: When this value is selected, the Interface drop-
down list is displayed. Select an existing WAN connection
from the list.
•
Default gateway: When this value is selected, the router uses
the default WAN connection.
The NAT Traversal function allows VPN traffic to pass through the
NAT-enabled device. DIR-882 allows to forcibly encapsulate VPN
traffic in UDP packets for passing through a remote device regardless
of whether it supports address translation.
If you need to enable forced encapsulation of VPN traffic, select the
Enabled value.
If you need to disable forced encapsulation of VPN traffic, select the
Disabled value.
Page 134 of 303
Configuring via Web-based Interface
Description
Click the Show