D-Link DIR-882 User Manual page 223

DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Figure 174. The window for changing the settings of the router's port.
In the opened window, specify the needed parameters:
Parameter
Speed
Data transfer mode.
Select the Auto value to enable autonegotiation.
selected, the Autonegotiation Modes and Flow control sections
are displayed.
Select the 10M-Half, 10M-Full, 100M-Half, or 100M-Full value
to manually configure speed and duplex mode for the selected port.
•
10M-Half: Data transfer in just
can be either sent or
of up to 10Mbps.
• 10M-Full:
Data transfer in two directions simultaneously
(data can be sent and received at the same time)
maximum possible
•
100M-Half: Data transfer in just
can be either sent or
of up to 100Mbps.
• 100M-Full:
Data transfer in two directions simultaneously
(data can be sent and received at the same time)
maximum possible
Page 223 of 303
Configuring via Web-based Interface
Description
one direction at a time
received) at the maximum possible
rate of up to 10Mbps.
one direction at a time
received) at the maximum possible
rate of up to 100Mbps.
When this value is
(data
rate
at the
(data
rate
at the