Linksys PCMLM56 User Manual page 73

Transmission Problems
• Data is garbled during or after transmission
You may be using a noisy line; try the transmission
again. Try turning on RTS/CTS flow control—this may
give your PC more time to react to incoming/outgoing
data. Make sure that all PCs and modems are communi-
cating with the same protocols and speeds. If you have
call waiting, disable it.
• The characters on the screen are doubled
Both the modem and the software have the echo feature
turned on. Since only one echo is needed, turn the soft-
ware echo feature off.
• The remote modem is echoing your typed charac-
ters
Type ATE1 then Enter at the command line. Then turn
off the software echo feature.
• No text appears on the screen when in data mode
The remote modem is not echoing your typed charac-
ters. Type ATE0 and press Enter at the command line.
Then turn the software echo feature on.
Your software may not be set to use Full Duplex or the
remote modem may not be set to use Full Duplex either.
• No text appears on the screen when in command
mode
If you can't see the characters you are typing, then type
ATE1 and press Enter.
71
Appendix