Linksys PCMLM56 User Manual page 46

Windows NT
Choose AutoSense for the Connection Type. Good val-
ues to start with for the other settings are 0x300 and
0x320 (for the I/O Port) and Auto (for the IRQ). For
more information, see page 7. Also choose the COM
Port and IRQ that the modem will use. Do not enter set-
tings that are being used by another device.
If you're not sure of the interrupt and other resource val-
ues that are available for use on your PC, click on Start,
then Run. Type WINMSD and press Enter. Click on
the Resources tab. Look at the IRQs that are already in
use and choose one that is unused. To check the I/O val-
ues, click on the I/O Port button.
8. When you're finished entering your I/O and Interrupt
values, click on Continue. NT will copy necessary
workstation files to your computer.
9. If you have installed the TCP/IP protocol, the Setup
will ask you if you will be obtaining IP addresses from
a DHCP server. If you click Yes, continue on to step
number 10. If you click No, you will need to obtain the
necessary TCP/IP information from your Network
Administrator to complete the TCP/IP properties
requirements.
When the Network Setup Wizard reappears, configure
your bindings. See your Windows NT User Guide for
more information on bindings.
10. When the bindings are configured, click Next, fol-
lowed by Next again to start the network.
11. When the Network Wizard window reappears, enter
a name for your computer. You can name it whatever
you would like, (Mary's Computer, Tardis, etc.).
44