Linksys PCMLM56 User Manual page 15

The new EMM386 line now looks something like this
(it may vary slightly, depending upon how the line
looked when you first found it in the file):
DEVICE=EMM386.EXE NOEMS X=D000-D7FF
If there are already commands on the EMM386 line, try
not to disturb them when you add the new command.
7. When you're finished, save your new CONFIG.SYS.
(If you are using the DOS Editor, for example, you can
click on Alt-F for File, then press S for Save).
8. Next, load your AUTOEXEC.BAT file for editing in
the same way you loaded the CONFIG.SYS.
Add the following command line to the beginning of the
file:
c:\carden.exe /IOP=i /IRQ=9 /COM=c
/MIR=mi /slt=5
where i equals the I/O address of the network portion
c equals the COM port to use
q is the IRQ value of the network portion
mi equals the I/O address of the modem
slt equals the slot
This command will run the client enabler program
each time your computer is started up. Note: If you do
not include any of the switches after carden, the pro-
gram will automatically choose them for you.
For example, to use IRQ 10, I/O 320, COM 2 with a
modem IRQ value of 3 in slot O you'd use:
13
Services