Linksys PCMLM56 User Manual page 16

Services
c:\carden /IRQ=10 /IOP=320 /COM=2
/MIR=3 /slt=0
9. Save your new AUTOEXEC.BAT file. The card and
socket services setup is complete.
Power down your computer and insert the EtherFast
10/100 + 56K Modem PC Card into one of your PC's
PCMCIA slots.
Restart your PC. When the enabler command in the
AUTOEXEC.BAT file is executed, you should see a
message that looks similar to this scroll by (it may
vary):
PCMCIA Ethernet Client Driver v3.00
IO Base = 0X030, IRQ=10, COM=02, MIR=3, slot = 0
You may also hear an audible tone indicating that the
card was successfully initialized.
If you received an error message, or a message stating
that the 10/100 + 56K Modem PC Card was not
installed successfully, you might need to change the
card's IRQ, I/O, COM, modem IRQ, or slot settings. Try
different values until you find a combination that works.
Remember that each time you try a different value with
enabler, you should also change the value in your com-
munication software. For more general information
about I/O and IRQ settings, see page 7.
To check to settings assigned to the card, run the follow-
ing command from a DOS prompt:
c:\carden /chk
14