Linksys PCMLM56 User Manual page 24

Windows 98
The installation is complete. Remember to remove the
installation disk from the floppy drive.
Look at the EtherFast PC Card's cable housing. If your
cabling is properly attached and the network is detected,
the Link light will be on, and the Activity (ACT) light
will be flickering or solid. If you are connected to a
100Mbps hub, the 10/100 light will be lit.
18. Once the computer has restarted and Windows is up,
a Logon window will appear requiring you to enter a
username and password. Make up a username and pass-
word, enter them, and click OK.
D click the Cancel button, or you won't be able to
O NOT
log onto the network. If the a logon does not appear or
if it does not allow you to log on, refer to problem 3 in
the Troubleshooting section in the back of this guide.
19. Once you are at the Windows 98 desktop, double-
click on the Network Neighborhood icon. You should
see the name of the network, and/or the names of the
other PCs on the network. In order to see your computer
in Network Neighborhood, you need to enable file and
printer sharing, which is covered on pages 24-26.
If you don't see anything at all, press the F5 key on your
keyboard a few times to refresh the screen.
If you only see your computer in Network
Neighborhood, skip to problem 6 on page 64 of the
Troubleshooting section.
If you see all computers on the network except yours,
and the other PCs can't see your computer, see problem
7 in the Troubleshooting section.
22