Chery A1 2009 Service Manual page 471

6.
CHECK THE HYDRAULIC PRESSURE SENSOR
• Replace the hydraulic pressure sensor with a known good sensor.
• Start the vehicle and monitor the value of HYDRAULIC PRESSURE with the X-431 scan tool.
Is the check result normal?
Yes >>
Go to the next step.
No >>
Replace the hydraulic pressure sensor.
7.
CHECK DTC
• With the X-431 scan tool, read AMT control module DTCs.
• Refer to DTC Confirmation Procedure .
Is DTC P0932 still present?
Yes >>
Replace the AMT control module (See AMT Control Module Removal & Installation in Section 08
Transaxle).
No >>
The system is now operating properly.
Reassemble the vehicle and road test to verify the customers complaint is repaired.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
08
95
08–