Chery A1 2009 Service Manual page 757

NOTE :
While performing electrical diagnosis & testing, always refer to the electrical schematics for specific circuit
and component information.
Diagnostic Procedure
1.
CHECK RCM DTC
Perform the DTC Confirmation Procedure.
I s DT C B 2214 present?
Yes >>
Go to the next step.
No >>
The system is now operating properly.
Reassemble the vehicle and road test to verify the customers complaint is repaired.
2.
CHECK WARNING LAMP
Turn ignition switch off, and wait a few seconds, then turn ignition switch on.
Observe the airbag warning lamp.
I s the airbag warning lamp not illuminated with the ignition switch ON?
Yes >>
Go to the next step.
No >>
Go to step 4.
3.
CHECK RESTRAINTS CONTROL MODULE (RCM) ELECTRICAL CONNECTOR
Turn ignition switch off.
Disconnect the Restraints Control Module (RCM)
electrical connector (1).
Inspect the electrical connector for damage.
I s the electrical connector OK ?
Yes >>
Go to the next step.
No >>
Repair or replace the electrical connector
as necessary.
4.
CHECK WARNING LAMP CIRCUITS
WARNING!
To avoid serious or fatal injury, turn ignition switch off, disconnect the negative battery cable and wait two min-
utes before proceeding.
Disconnect the instrument cluster electrical connector C-001.
Disconnect the body fuse and relay box C-020.
NOTE :
Check connectors - Clean and repair as necessary.
34
14–
DIAGNOSIS & TESTING
PZSMD140013
Chery Automobile Co., Ltd.