Removal & Installation - Chery A1 2009 Service Manual

Removal & Installation
NOTE :
The ECM is located on the driver side lower shroud of the instrument panel.
1. Disconnect the negative battery cable.
2. Remove the ECM mounting bolts (1).
(Tighten: ECM mounting bolts to 10 N·m)
3. Disconnect the ECM electrical connector.
4. Remove the ECM.
5. Installation is in the reverse order of removal.
Installation Notes:
NOTE :
The Immobilizer control module must be matched to the new ECM before the engine will start.
Matching Immobilizer Control Module to new Engine Control Module (ECM)
Perform the following to match the Immobilizer control module to the ECM:
− With the X-431 scan tool, choose A1 series.
− Choose immobilize .
− Choose input code .
− Input the safety code.
− Click the small keyboard.
− Click OK .
− Choose Immobilizer adapt .
− Choose read Immobilizer to ECM immediately.
− Click OK .
Chery Automobile Co., Ltd.
ON-VEHICLE SERVICE
03
PZSM030021
177
03–