Chery A1 2009 Service Manual page 390

23. Remove the transaxle rear mount bolt (2) and
bracket bolts (1).
(Tighten: Transaxle rear mount bolts to 60 ± 5 N·m)
24. Remove the engine to transaxle bolts (1).
(Tighten: Engine to transaxle bolts to 70 ± 5 N·m)
25. Remove the sub-frame assembly (See Sub-Frame Removal & Installation in Section 11 Steering).
26. Separate the transaxle from the engine and remove it from the vehicle.
WARNING!
Support the transaxle with a suitable jack while removing the transaxle.
27. Installation is in the reverse order of removal.
Installation Notes:
• When installing the transaxle, be careful to avoid interference between the transaxle input shaft and the clutch.
• After transaxle installation, remove the fill hole plug
(1) and fill the transaxle fluid to the proper level.
NOTE :
When filling the transaxle with fluid, fill the transaxle
until the fluid is even with the fill hole plug.
− Transaxle fluid quantity: 1.8L
14
08–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
PZSM020011
VISM080002
VISM080013