Chery A1 2009 Service Manual page 695

Recirculation Door Actuator
Removal & Installation
1. Disconnect the negative battery cable.
2. Remove the instrument panel (See Instrument Panel Removal & Installation in Section 15 Body & Accessories).
3. Remove the HVAC housing (See HVAC Housing Removal & Installation in Section 13 Heating & Air Condition-
ing).
4. Disconnect the recirculation door actuator harness connector.
5. Remove the three screws (1) from the recirculation
door actuator.
(Tighten: Recirculation door actuator screws to 2
N·m)
6. Remove the plastic clip from the recirculation door actuator.
7. Remove the recirculation door actuator.
8. Installation is in the reverse order of removal.
Installation Notes:
• Turn the ignition switch to the ACC position.
• Start the engine and turn on the air conditioner.
• Set the air conditioner temperature adjusting knob to HOTTEST or COLDEST temperature setting.
• Close the air conditioner panel until the motor stops.
• Adjust the mixing damper manually to HOTTEST or COLDEST temperature setting.
• Adjust the rod to align with the recirculation door actuator.
• Attach the rod to the recirculation door actuator.
18
13–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
PZSM130007