Chery A1 2009 Service Manual page 469

Diagnostic Procedure
1.
CHECK HYDRAULIC PRESSURE SENSOR SIGNAL
• With the scan tool, select view DTC and data
stream for AMT.
• Start vehicle and monitor the value of HYDRAULIC
PRESSURE .
ITEM
System Pressure
Is the check result normal?
Yes >>
The conditions that caused this DTC to set are not present at this time (See Diagnostic Help in Section
08 Transaxle).
No >>
Go to the next step.
2.
CHECK HYDRAULIC PRESSURE SENSOR ELECTRICAL CONNECTOR
• Stop the vehicle and turn ignition switch off.
• Disconnect the hydraulic pressure sensor electrical
connector P-009.
• Inspect the electrical connector for damage.
Is the electrical connector OK?
Yes >>
Go to the next step.
No >>
Repair or replace the electrical connector
as necessary.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
CONDITION
Idle or driving
PZSMD080031T
DISPLAY VALUE
40 - 52 bar
PZSMD080001
93
08–
08