Bowflex BXT8J Service Manual page 81

12. Lightly attach the Motor Assembly to the Frame. Be sure to only finger
tighten the hardware.
13. Loop the Drive Belt onto the Motor Pulley. With the Drive Belt looped onto
the Motor, carefully roll the Drive Belt onto the Drive Pulley.
14. Wrap the new Drive Belt around the Motor Pulley. Start the Drive Belt on the
Drive Pulley and roll it in a clockwise motion. Be sure the Belt does not come off
of the Motor Pulley.
Keep fingers out of any pinch opportunities when turning the
Pulleys.
15. Roll the Drive Pulley clockwise until the Drive Belt is fully installed. Continue
to roll the Belt forward while adding side pressure with fingers to align as neces-
sary.
16. With the Motor Assembly loosely attached to the Frame, turn the Belt Ten-
sioner Screw to the previous level. This will tighten the Drive Belt to the previous
tension level.
17. Using a 6mm hex wrench, fully tighten the screws that attach the Motor Assembly to the Frame.
18. Connect the Motor Connectors to the Motor Control Board following the previous route.
Note: Be sure to attach the cables to the proper locations on the Motor Control Board. Do not pinch or cut any of the cables.
19. Secure the Motor Cables using the replacement Zip-Ties.
20. Re-install all remaining parts that were removed in reverse order.
21. Attach the power cord and turn on the Treadmill by flipping the power switch to ON.
22. From the Power Up (or Welcome) screen, push and hold down the PAUSE/STOP button and Down arrow button for about 5 seconds to go into
the Machine Setting Mode. The Console display will show the TOTAL HOURS screen.
23. Push and hold down the PAUSE/STOP button and Down arrow button for about 5 seconds to go into the Engineering Mode.
24. Push the Down arrow button 12 times until the Console displays "ENTR MCB CLB".
Be sure the area around the Treadmill is clear of all bystanders, children and pets. Be sure there is nothing on or under the Walking
Belt, or near the Treadmill.
25. The Console will display "MCB CALIB".
Belt Tensioner Screw
81
Drive Pulley
Drive Belt
Motor Pulley
Motor