Note: Your machine may not match the provided images exactly.
19. Using a 6mm hex wrench, remove the 4 indicated screws from each
side of the Walking Deck.
20. Slide the old Walking Deck Assembly out of the Walking Belt, and flip
over so the Walking Belt Guides are exposed.
Securing Tab
New Walking Deck
21. Using a #2 Phillips screwdriver, remove the Walking Belt Guides and
Walking Belt Guides
attach them to the new Walking Deck as shown.
Note: The Walking Belt Guides must be attached to the new Walking
Deck on the side with the Securing Tabs.
Securing Tab
22. Turn over the new Walking Deck Assembly, and slide it between the
Walking Belt with the Walking Belt Guides down and to the front of the
machine.
Walking Belt Guide
Securing Tab
147