Bowflex BXT8J Service Manual page 102

10. Make sure there is sufficient space to lower the walking deck.
Keep a minimum clearance behind the machine of 79" (2 m)
and 19.7" (0.5 m) on each side. This is the recommended safe
distance for access, movement and emergency dismounts
from the machine.
11. Make sure there is no object on or around the treadmill to spill or
cause blockage from the fully unfolded position.
12. Slightly push the walking deck forward toward the console. With your
foot lightly push the top part of the hydraulic lift forward until the locking
tube releases and you can pull the walking deck away from the console.
Hold up the rear of the walking deck, and move to the side of the machine.
Keep clear of the movement path of the walking deck.
13. The hydraulic lift is set up to drop gradually. Hold onto the walking
deck until approximately 2/3 of the movement down. Lower the weight
with your legs. Be aware that the walking deck can possibly drop quickly
in the last part of the movement.
14. Using a 6mm hex wrench, finish removing both of the Adjustment
Bolts from the Rear Roller.
Note: Be sure to record the number of turns of the Adjustment Bolt it takes
to remove it. This will assist with reassembly.
15. Slide the Rear Roller out of the Walking Belt.
16. Slide the new Rear Roller into the new Walking Belt in the same
orientation.
17. Using a 6mm hex wrench, re-attach the Adjustment Bolt to the Rear
Roller.
Note: Be sure to tighten the Adjustment Bolt the same number of turns it
took to loosen the Walking Belt.
18. Re-install all remaining parts that were removed in reverse order.
19. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's
Manual.
Rear Roller
102