Note: Your machine may not match exactly.
9. Using two 17mm wrenches, remove the hardware from the
Incline Motor Assembly.
10. Using a 16mm and a 17mm wrench in the Motor Compart-
ment, remove the hardware from the Incline Motor Assembly.
Remove the Incline Motor Assembly noting how it extends from
the Motor Compartment through to the Incline Weldment.
11. Installation of the Incline Motor Assembly is the reverse
procedure.
Note: Be sure to attach the cables to the proper locations on the
Motor Control Board. Do not pinch or cut the cables.
12. Make sure that there is safe clearance beside the tread-
mill to one side. Make sure there is sufficient space to tilt the
machine back upright.
This step requires two people. Be sure there is
adequate clearance for the raised deck. Some
components of the equipment can be heavy or
awkward. Enlist the service of a second person when
you do maintenance steps involving these compo-
nents. Do not try to do heavy or awkward steps on
your own.
Incline Weldment
60
Incline Motor Assembly
Incline Motor Assembly