!
1. Unplug the power cord from the machine and wait 5 minutes. Place the
power cord in a secure location.
2. Using a #2 Phillips screwdriver remove the 4 indicated screws, and two
additional screws on the far side, from the Motor Cover and remove it.
3. Using a #2 Phillips screwdriver remove the 2 indicated screws from the
MCB Cover and remove it.
4. Remove the connectors for the Lower Input/Output (I/O) Cable from the
Motor Control Board after noting its location.
Note: Be sure to note where all cables attach for re-assembly.
5. Using a #2 Phillips screwdriver, disconnect the Grounding Cable from
the Frame Assembly.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power
cord from the wall outlet and wait 5 minutes before cleaning, maintaining or repairing this machine. Place
the power cord in a secure location.
Motor Cover
MCB Cover
68
Incline Motor Assembly
Motor Control Board
(MCB)