Bowflex BXT8J Service Manual page 39

7. Fully remove the Console Assembly from the Uprights.
8. With the new Console Assembly, attach the Console to the Uprights and
then Connect the Cables
Note: Be sure that the hooks on each side of the Console are seated in the
notches on the Uprights. Be sure to remove the ziptie or rubberband
that secures the I/O Cable from the Right Upright. Do not pinch or cut
the cables.
9. Re-install all remaining parts that were removed in reverse order.
Note: when re-attaching the Console Backing, be sure to attach the hard-
ware marked with the ( * ) first, then the hardware with the ( ** ), followed
by the remaining hardware.
10. Attach the power cord and turn on the Treadmill by flipping the power
switch to ON.
11. During the first power-up, the Console should be set up with the date,
time, and the preferred units of measurement.
Date: Push the Increase/Decrease buttons to adjust the currently active
value (flashing). Push the Left/Right buttons to change which segment is
the currently active value (month / day / year).
12. Push OK to set.
13. Time: Push the Increase/Decrease buttons to adjust the currently ac-
tive value (flashing). Push the Left/Right buttons to change which segment
is the currently active value (AM or PM / hour / minute).
14. Push OK to set.
15. Units of Measurement: Push the Increase/Decrease buttons to adjust
between "MILES" (Imperial English) or "KM" (metric).
16. Push OK to set. The Console goes to the Power-Up Mode screen.
17. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
**
*
39
X13
B
#2
*
**