Bowflex BXT8J Service Manual page 80

5. Using a #2 Phillips screwdriver, disconnect the Motor Ground Wire from
the Frame.
6. Using a 6mm hex wrench, loosen the indicated screws (by arrows) on the
Motor Mount.
7. Using a 13mm Open Ended Wrench, rotate the Belt Tensioner Screw
enough to loosen the Drive Belt.
Note: To assist with reassembly, be sure to record the number of threads
exposed before loosening.
8. Using a 6mm hex wrench, remove the indicated screws (by arrows) from
the Motor Mount. Remove the Drive Belt and rotate the Motor Assembly
exposing the Motor Mount.
9. Cut the 3 Zip-Ties that secure the Motor Cables.
10. Using a 6mm hex wrench, remove the indicated hardware from the Mo-
tor Mount and remove the old Motor.
11. Attach the Motor Mount to the new Motor. Be sure the Belt Tensioner
Screw is properly oriented toward the rear of the machine when the Motor is
re-installed.
Belt Tensioner Screw
Motor Mount
Motor Cables
Zip-Tie
80
Drive Belt
Motor