Bowflex BXT8J Service Manual page 61

13. Make sure there is sufficient space to lower the walking deck.
Keep a minimum clearance behind the machine of 79" (2
m) and 19.7" (0.5 m) on each side. This is the recommend-
ed safe distance for access, movement and emergency
dismounts from the machine.
14. Make sure there is no object on or around the treadmill to spill or
cause blockage from the fully unfolded position.
15. Slightly push the walking deck forward toward the console. With
your foot lightly push the top part of the hydraulic lift forward until the
locking tube releases and you can pull the walking deck away from the
console. Hold up the rear of the walking deck, and move to the side of
the machine.
Keep clear of the movement path of the walking deck.
16. The hydraulic lift is set up to drop gradually. Hold onto the walking deck until approximately 2/3 of the movement down. Lower the weight with
your legs. Be aware that the walking deck can possibly drop quickly in the last part of the movement.
17. Re-install all remaining parts that were removed in reverse order.
18. Attach the power cord and turn on the Treadmill by flipping the power switch to ON.
19. From the Power Up (or Welcome) screen, push and hold down the PAUSE/STOP button and Down arrow button for about 5 seconds to go into
the Machine Setting Mode. The Console display will show the TOTAL HOURS screen.
20. Push and hold down the PAUSE/STOP button and Down arrow button for about 5 seconds to go into the Engineering Mode.
21. Push the Down arrow button 12 times until the Console displays "ENTR MCB CLB".
Be sure the area around the Treadmill is clear of all bystanders, children and pets. Be sure there is nothing on or under the Walking
Belt, or near the Treadmill.
22. The Console will display "MCB CALIB".
23. With the area clear, push the ENTER button. The calibration procedure will begin by automatically moving the Walking Belt.
Be sure not to touch or allow anyone else to touch the machine while calibration is occurring.
24. When calibration is complete, the Console will display "DONE".
25. Push the PAUSE/STOP button to exit the Engineering Mode.
26. Flip the power switch to OFF. Calibration is now complete for the machine.
61