Bowflex BXT8J Service Manual page 149

30. If the Walking Belt needs to be adjusted, use a 6mm hex wrench on the side the
belt should move away from and rotate the Adjustment Bolt a 1/4 turn clock-wise.
31. Allow the Walking Belt to adjust to the new tension by allowing it to run a couple
seconds.
32. Repeat steps 30 and 31 until the Walking Belt is centered.
33. Switch off your machine.
34. Take care to clean up any excess lubricant from the deck.
To decrease the possibility of slipping, be sure the deck area is free
from grease or oil. Clean off any excess oil from the machine surfaces.
35. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and inspected
for correct performance in accordance with the Owner's Manual.
149