Bowflex BXT8J Service Manual page 75

12. Gently pull out the Input/Output (I/O) and Grounding Cables from the
Right Upright, and disconnect them. Do not allow the Cables to fall into
the Right Upright. Secure them with a Zip-Tie, rubber band or piece of
wire.
Note: Do not pinch or cut the Cables. Be sure not to allow the old Middle
I/O Cable to fall down into the Right Upright.
13. Gently pull the old Middle I/O Cable from the Right Upright, routing
the new I/O Cable through the Right Upright.
Note: Be sure that the cables do not pinch or cut when being routed.
14. Disconnect the old Middle I/O Cable, and dispose of it appropriately.
15. Connect the new Middle I/O Cable to the Upper I/O Cable.
16. Re-install all remaining parts that were removed in reverse order.
Note: Be sure the Cables are safely tucked into the Right Upright. When
re-attaching the Console Backing, be sure to attach the hardware marked
with the ( * ) first, then the hardware with the ( ** ), followed by the
remaining hardware.
17. Safely tilt the right side of the machine up, remove the incompress-
ible block or book from under the Base Assembly, and safely lower the
machine.
18. Make sure there is sufficient space to lower the walking deck.
Keep a minimum clearance behind the machine of 79" (2 m)
and 19.7" (0.5 m) on each side. This is the recommended safe
distance for access, movement and emergency dismounts
from the machine.
19. Make sure there is no object on or around the treadmill to spill or
cause blockage from the fully unfolded position.
20. Slightly push the walking deck forward toward the console. With
your foot lightly push the top part of the hydraulic lift forward until the
locking tube releases and you can pull the walking deck away from the
console. Hold up the rear of the walking deck, and move to the side of the
machine.
Keep clear of the movement path of the walking deck.
2
**
75
X13
B
#2
*
*
**