Bowflex BXT8J Service Manual page 65

6. Using a 13mm wrench and a 6mm hex wrench, remove the indicated hardware
(with ovals) from the Lift Shock Assembly.
Be aware that when the Lift Shock is released from the Frame Assem-
bly, the Lift Shock and Base Frame Weldment may abruptly move. Be
sure to keep clear of any potential pinch opportunities from this
motion.
7. Remove the old Lift Shock and attach the new Lift Shock.
8. Make sure there is sufficient space to tilt the machine back upright and that the
area is clear.
This step requires two people. Be sure there is adequate clearance for
the raised deck. Some components of the equipment can be heavy or
awkward. Enlist the service of a second person when you do mainte-
nance steps involving these components. Do not try to do heavy or
awkward steps on your own.
9. Make sure there is sufficient space to lower the walking deck.
Keep a minimum clearance behind the machine of 79" (2 m)
and 19.7" (0.5 m) on each side. This is the recommended
safe distance for access, movement and emergency dis-
mounts from the machine.
10. Make sure there is no object on or around the treadmill to spill or
cause blockage from the fully unfolded position.
11. Slightly push the walking deck forward toward the console. With
your foot lightly push the top part of the hydraulic lift forward until the
locking tube releases and you can pull the walking deck away from the
console. Hold up the rear of the walking deck, and move to the side of
the machine.
Keep clear of the movement path of the walking deck.
12. The hydraulic lift is set up to drop gradually. Hold onto the walking
deck until approximately 2/3 of the movement down. Lower the weight
with your legs. Be aware that the walking deck can possibly drop quickly
in the last part of the movement.
13. Re-install all remaining parts that were removed in reverse order.
65
Lift Shock