Change Click Volume During Clock Move Recording - Yamaha RY30 Authorized Product Manual

Change Click Volume During
Clock Move Recording
3. Press the instrument pad corresponding to the instrument you want to move
(if the instrument is not in the current bank press the [PAD BANK] key,
select the appropriate pad bank, and then press [EXIT] to return to the pre-
vious display). An instrument can also be selected by moving the cursor to
the instrument name and using the [INC] and [DEC] keys or the [DATA]
control. The name of the selected instrument will appear in the parentheses
on the bottom line of the display.
If you select the ride cymbal, for example, the display will look something
like this:
4. Press the [START] key to engage the clock move mode. The selected pat-
tern will begin playing and you can begin modifying the timing after a one-
measure count-in ("Count" will appear in the parentheses during the count-
in, then the instrument name will reappear when parameter modify begins).
5. Move the wheel upward to move the timing of notes forward (i.e. the notes
will occur earlier), or downward to move the timing backward (i.e. the notes
will occur later). Only notes of the selected instrument that occur while the
wheel is not in its center position will be affected —- that means you have to
move the wheel up or down just before the target note occurs, then release it
before notes you don't want to move occur. The note(s) will be moved by
—
one "clock" that's 1/24th of a quarter note
each pass (i.e. the amount by which the wheel is moved does not affect that
amount of time by which the notes are moved). You may have to move a
note several times in the same direction to achieve the desired effect.
6. You can select a different instrument (you can also select an entirely
different pad bank if necessary) at any time in the clock move mode.
Click volume can be adjusted in the clock move in the same way as it can in the
parameter modify mode: press the [PAGE] key, then use the [INC] and [DEC]
keys, the numeric keys, or the [DATA] slider to change the click (metronome)
volume as required (00 . . . 63).
Press the [EXIT] key to return to the normal clock move display.
—
in the specified direction on
31